Jailbreak

Jailbreak
Identifier:	West 1-Δ1
Area:	Western Delta
Puzzle Type:	Lost
Previous Puzzle:	Transference
Next Puzzle:	Vertical Locomotion

Jailbreak is a lost puzzle in the Western Delta area of The Talos Principle 2.

Puzzle elements

• Blue door
• Connector
• Emitter
• Pressure plate
• Rail drone
• Receiver

Overview

To reach this puzzle, as you walk from Puzzle 3 towards Puzzle 4, take the path to the left. You'll have to walk for quite a bit.

As you enter the puzzle, you see a red emitter in front of you. On both sides are long covered corridors, with grills on one side and blue doors on the ends, which look like jail cells. There is a passageway along the entire length that you can freely walk on. To the right, behind a tall grate is a blue emitter. At the very right end of the puzzle is a fixed connector that is statically linked to a red rail drone, which is currently inside the first jail cell. The path of the rail drone cuts across all the cells and turns a bit near the end. Outside, there are two connectors. On the far left, on an elevated platform, the progress wheel can be seen.

Starting from the point closest to the fixed connector, the first jail cell has the aforementioned red rail drone, and a blue door to the next cell. On the wall just outside is a red receiver.

The second jail cell has a blue receiver inside, and a blue door to the third cell.

The third cell has a pressure plate, and a blue door to the outside, just next to the entryway.

Across the entryway, the fourth cell is a single long passage; it has blue doors on either side. Close to the entryway is a pressure plate, but a section of the grill is missing, so one can freely enter the cell. On the other end is a red receiver, and the grill is only half-height near this section.

Hints

A basic hint:

[ hint ]

Since the name of the puzzle is Jailbreak, you will have to figure out how to get the rail drone to exit each of the jail cells, one by one.

If you're struggling to get started:

[ hint ]

Carefully note the fixed connector on the far end of the puzzle area. Use that connector for the first part of the puzzle

If you're struggling to get the rail drone out of the third room:

[ hint ]

If you activate the rail drone immediately, it steps off the pressure plate and the blue door activates, which prevents the rail drone from moving. How can you keep the pressure plate active?

If you've brought the rail drone to the left jail cell, but can't find a good angle for the rail drone:

[ hint ]

Think about the left section, where there was a fixed connector providing energy to the rail drone. That fixed connector is not available anymore, but is there an equivalent replacement now?

If you're mourning the loss of some equipment:

[ hint ]

If you think that you had to sacrifice one of your connectors on the pressure plate on the third room, don't worry. It can still be useful from there

Solution

[ solution ]

• 
  Step 1: Connect the blue emitter to the blue receiver in cell 2, and place the connector on the rail drone.
• 
  Step 2: Use the other connector to activate the red receiver outside cell 1, and the fixed connector as well, which activates the rail drone. Wait until the rail drone reaches all the way to cell 3.
• 
  Step 3: The rail drone is currently pushing down on the pressure plate, but it will need to move soon, so we place one of the connectors on the pressure plate.
• 
  Step 4: Activate the rail drone from outside, directly using a connector. Walk into the fourth cell and push the pressure plate so that the rail drone can come inside.
• 
  Step 5: Walk back into cell 3 and connect the connector to the rail drone, and place it in the middle of the pressure plate.
• 
  Step 6: Activate the rail drone via the connector in cell 3. Stand on the pressure plate until the rail drone reaches the end of the cell.
• 
  Step 7: Connect the outside connector to the emitter, the connector in cell 3, and the red receiver near the end of the cell, and place it on the rail drone.
• 
  Step 8: Go back and stand on the pressure plate. The rail drone is activated, and reaches outside. Step off once it starts moving sideways.
• 
  Step 9: Remove the connector from the rail drone, and jump on it, and then onto the platform to reach the progress wheel.