Voyager

Voyager
Identifier:	Abyss-6
Area:	Into the Abyss
Previous Puzzle:	Tritogeneia
Next Puzzle:	Stylite

Voyager is the sixth puzzle in Into the Abyss, part of the Road to Elysium expansion for The Talos Principle 2.

Puzzle Elements

• Blue door
• Connector
• Driller
• Emitter
• Fan
• Hexahedron
• Pressure plate
• Receiver

Overview

The puzzle area is separated into multiple rooms:

• The main room contains two cells blocked off by Blue doors controlled by Pressure plates. One contains a Hexahedron, the other one a blue Emitter required to access the Progress Wheel.
• A second room contains a Connector pre-connected to a red Receiver.
• A third room contains a detachable Fan controlled by a Pressure plate.
• A fourth room locked from the inside contains a Driller.

Hints

If you have trouble getting started:

[ hint ]

Notice that the Fan is detachable. You can use it for Pressure plates.

If you have an item stuck in the Driller room:

[ hint ]

Notice that the bronze wall near the Pressure plate is close enough to grab an item through it.

If you have trouble moving the Connector:

[ hint ]

You can't pick up the Connector and expect the Blue doors to remain open. Can you find a way to get out of the room first and then take the Connector?

Solution

[ solution ]

• 
  Add the second red Receiver to the Connector's targets.
• 
  Take the Fan blades and put them on the Pressure plate by the Hexahedron.
• 
  Take the Hexahedron and place it on the Pressure plate by the Fan.
• 
  Jump onto the Fan.
• 
  Place the Driller on the nearby Pressure plate.
• 
  Fetch the Hexahedron and swap it for the Driller on the Pressure plate.
• 
  Bring the Driller in the main area, and drill the wall in front of the Hexahedron.
• 
  Grab the Hexahedron through the hole and place it back onto the Pressure plate by the Fan.
• 
  Bring the Driller inside the Fan room and drill the wall by the Blue door.
• 
  Move the Connector to bring in front of the hole.
• 
  Grab the Connector from the inside of the room.
• 
  Drill the wall to the room where the Driller used to be.
• 
  Place the Connector through the hole.
• 
  Take the Driller and jump onto the Fan.
• 
  Place the Connector on the Pressure plate.
• 
  Bring the Driller in the main area, and drill the wall in front of the Connector.
• 
  Take the Connector through the hole, connect it to the blue Emitter and to the blue Receiver by the Progress Wheel, and place it down on the Pressure plate by the Emitter.
• 
  Drill the wall blocking the laser and finish the puzzle.